Tile roofs are one of the most common types of roofs throughout the world, and are also one of the oldest types of roofs. Used in most parts of the world, these roofs can last between 25 and 50 years depending on how well they are installed and maintained. If you want to keep your tile roof for more than five decades, you will need to install flashing to keep water on top of the tiles, with the underlayment only serving as secondary protection. Read on to learn more about all the areas that your roof is missing flashing and give you some tips on how to double the lifespan of your tile roofing. Certified Roofers & General Contractors, Inc. provides roof repair Riverview FL residents trust. Call Certified Roofers & General Contractors, Inc. at our Valrico office to find out more today!
Over 90% of tile roofs in Florida don’t have flashing, allowing water and moisture to run under the tiles and rely solely on the underlayment to keep the home dry. Water flowing under the tile will gradually break down the underlayment and shorten its lifespan through deteriorating, cracking, and eventually resulting in leaks. This is why certain tile roofs in Florida start to leak in just 5 years and may need replacement in 25 years or so. Luckily, you’re able to install these protective flashings at any time and double the life of your tile roof! All you have to do is work with an experienced tile roofer to inspect your roof and put forward the right flashings. Tile roofing is one of the most durable types of roofing for residential properties, and are extremely resistant to damage caused by severe storms, earthquakes, hurricanes, and fires. In order to make your tile roof last, however, you’ll want to have roof flashings.
Flashing is used to secure different joints in your roof, such as where your roof meets a wall or chimney, valleys, and around vents. Penetrations for chimneys, vent pipes, skylights, roof vents, valley junctures, headwalls, and roof-to-wall and pitch transitions also need flashings. These areas are more prone to leaks during downpours, which is why it’s key to install flashings. Flashings are engineered to direct water away from the vulnerable areas of your roof, such as the valleys between slopes and around the roof’s gutter system. While adding flashing will raise the cost of roof installation, you’ll end up saving more money in the long run. It can help to stop serious leaks that can cause damage to your tiles or underlayment. Once the underlayment weakens due to water damage, the structural integrity of your tile roof will be compromised. Moreover, the heavy weight of tile roofing can make the situation much worse if there is a weakened underlayment.
Installing roof flashing can help to protect your tile roofing. Certified Roofers & General Contractors, Inc. provide roof repair Riverview FL residents love. Call Certified Roofers & General Contractors, Inc. at our Valrico office to find out more today!
Attaining GAF Master Elite® Certification is no small feat for a roofing contractor. It is…
In the realm of home maintenance and improvement, choosing the right contractor to repair or…
Hiring a roofing contractor is a significant decision for any homeowner, especially in areas where…
While aesthetics matter, homeowners must consider more than beauty when choosing a replacement roofing material.…
Many people do not address roofing problems until it's too late. It's time to take…
Protecting your home from hail damage is a top priority for homeowners, especially regarding your…